23Jul
22Jul
Steering wheel, vertical play
23 tacoma, 63k miles, in New England, lots of rough Maine roads, North Maine woods and Golden road, Been chasing down a noise. Front suspension is good, already checked t hat. I noticed that I have clicking sound when the vehicle is stationary, not moving....
22Jul
What camera are you shooting with?
I'm useing a canon t2i with 18-55 and 55-250 first dslr i bought.
22Jul
2020 Tacoma SR 2.7L Sputters
Hello, as it says in the title, I have a 2020 Tacoma SR. 2.7L 36,000 miles. It has run perfectly for five years, about one year ago I was out on a late night drive. Approximately 30 mins into the drive I stopped at a...
22Jul
Upgraded Alignment Hardware kits recommendations
Bent my cam tabs off roading… i do not know much about alignment byond the basics of caster, camber, and toe. Since stuff is bent, i figure I should upgrade instead of replacing with OE. Looking at Total Chaos gusseted cam tabs https://www.tacomaworld.com/threads/total-chaos-lca-cam-tab-gussets-install.362440/ and KP offroad octagonal...
21Jul
Overloaded rear suspension
Hey guys just got back from a little camping trip and was noticing the truck needs a little love. Front has its own list of issues but the rear is where I’m starting. Truck has a fiberglass canopy full time, in the bed drawer system...
21Jul
Engine pull
Good Morning All. Have a 2011 Tacoma that i am going to pull the engine and replace with a salvage. i believe i am capable, but would like to know if it i should have the AC evacuated so i can disconnect that...
21Jul
South Carolina BS thread under new MANAGEMENT and lives in SC
Original OP: scottalot said: ↑ @ClemsonMGM @misdirection1982 ... Click to expand... South Carolina BS thread under new MANAGEMENT and lives in SC
21Jul
What adhesive would you recommend?
I have a 2022 Tacoma and in the very back of the sides near the bottom, there are black plastic trim pieces. I noticed they are starting to come loose and lift up. I am concerned water and dirt will accumulate under the...
20Jul

