Author - Christain Parker

Check out If It Fitz

Christain Parker2026-07-23T14:29:46+00:00Hey so I started this thread out to get some votes for a contest that is now over; for those of you who voted, thank you very much. for those of you who are new to the thread, I plan, from here on out, to...

Anyone else hate their job?

Christain Parker2026-07-23T14:29:34+00:00I'm 33 years in (at the same place) and I hate mine. My actual job is fine, it's everything else sucks. Back in the day it used to pay good, but everyone has passed us by over the years. We've always had trouble keeping people,...

Steering wheel, vertical play

Christain Parker2026-07-22T14:12:41+00:0023 tacoma, 63k miles, in New England, lots of rough Maine roads, North Maine woods and Golden road, Been chasing down a noise. Front suspension is good, already checked t hat. I noticed that I have clicking sound when the vehicle is stationary, not moving....

What camera are you shooting with?

Christain Parker2026-07-22T14:12:29+00:00I'm useing a canon t2i with 18-55 and 55-250 first dslr i bought.

2020 Tacoma SR 2.7L Sputters

Christain Parker2026-07-22T14:12:11+00:00Hello, as it says in the title, I have a 2020 Tacoma SR. 2.7L 36,000 miles. It has run perfectly for five years, about one year ago I was out on a late night drive. Approximately 30 mins into the drive I stopped at a...

Upgraded Alignment Hardware kits recommendations

Christain Parker2026-07-22T14:09:27+00:00Bent my cam tabs off roading… i do not know much about alignment byond the basics of caster, camber, and toe. Since stuff is bent, i figure I should upgrade instead of replacing with OE. Looking at Total Chaos gusseted cam tabs https://www.tacomaworld.com/threads/total-chaos-lca-cam-tab-gussets-install.362440/ and KP offroad octagonal...

Overloaded rear suspension

Christain Parker2026-07-21T13:52:39+00:00Hey guys just got back from a little camping trip and was noticing the truck needs a little love. Front has its own list of issues but the rear is where I’m starting. Truck has a fiberglass canopy full time, in the bed drawer system...

Engine pull

Christain Parker2026-07-21T13:51:38+00:00Good Morning All. Have a 2011 Tacoma that i am going to pull the engine and replace with a salvage. i believe i am capable, but would like to know if it i should have the AC evacuated so i can disconnect that...

South Carolina BS thread under new MANAGEMENT and lives in SC

Christain Parker2026-07-21T13:51:06+00:00Original OP: scottalot said: ↑ @ClemsonMGM @misdirection1982 ... Click to expand... South Carolina BS thread under new MANAGEMENT and lives in SC

What adhesive would you recommend?

Christain Parker2026-07-21T13:49:53+00:00I have a 2022 Tacoma and in the very back of the sides near the bottom, there are black plastic trim pieces. I noticed they are starting to come loose and lift up. I am concerned water and dirt will accumulate under the...